Calculated Industries Scale Master Classic Manuel d'utilisateur télécharger pdf (Page 11)

11 – User’s Guide

iii.Press [Scale] to advance through

the flashing digits until the display

returns to zero. The height is now

stored.

b. T

o Enter and Store a Height:

i. If you are entering a height (instead

of rolling), press [Subtract/Count]

and [M2x] simultaneously. The unit

of measure will begin flashing.

ii. If you do not want to change the

unit of measure, go to step iii. To

change the unit of measure, press

[M1+] until you reach the desired

unit.

iii.Press [Scale] to begin setting the

digits. The left-most digit will

begin flashing.

Press:

[M1+] to increment this digit,

[Subtract/Count] to decrement,

[Scale] to advance to next digit,

[Mode] to move back one digit.

iv. Continue pressing [Scale] until all

digits are set and the display returns

to zero. The height is now stored.

Note: Once you set your height, you do not need

to enter it again unless you want to change it.

4) Press [Rcl] [M2x]. This displays the

linear value stored in this register.

Press [M2x] a second time to calculate

and display the area. Press the [M2x]

key again to find volume. Press [M2x]

a fourth time to display the stored

height value.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Commentaires sur ces manuels

Pas de commentaire