Calculated-industries 6260 User Guide Manuel d'utilisateur télécharger pdf (Page 38)

There are two methods for programming Custom Scales

into your Ultra Scale Master Pro. “Measured Custom Scales”

allow you to measure a speciﬁ ed Length and assign the

known value. “Entered Custom Scales” allow you to enter

and set a known scale that is not included within the

available built-in scales of the Ultra Scale Master Pro.

Four Custom Scales can be stored in Imperial and Metric

Modes for a total of eight Custom Scales. Once a Custom

Scale has been set in either mode, it is retained until a new

scale is stored in its place or until an All Clear or Reset is

performed. Switching between Imperial and Metric Modes

does not clear stored Custom Scales.

SETTING A MEASURED CUSTOM SCALE

CUSTOM SCALES

1. Press [MODE] until “CUST” is displayed. Press [SCALE]

to scroll through the four available custom scales. For this

example, Custom Scale-1 is used.

2. Press [SET] then [SCALE] to begin setting the Custom

Scale. The display prompts you to enter Point-1.

3. Place the crosshairs over the start point of the line and

press [MEASURE]. You are prompted to enter Point-2.

4. Place the crosshairs over the end point and press

[MEASURE]. The display shows “0,000-00” for Imperial

Mode and “00,000.0” is displayed for Metric Mode.

36 — ULTRA SCALE MASTER

PRO

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Pas de commentaire

Calculated-industries 6260 User Guide Manuel d'utilisateur Page 38